Bathroom Work We Handle in Sterling
Everything in the room that carries water in or out. These are the recurring jobs, from the ten-minute class to the remodel class.
Toilet leaking at the base
A failed wax seal or a flange sitting below floor level lets flush water escape under the toilet, rotting the subfloor silently. Rocking toilets accelerate the failure — this is a pull-and-reseal job with a flange inspection, not a caulk job.
Running or weak-flushing toilet
Worn flappers, scaled flush valves, and tired fill valves waste water and flush poorly. Sterling's mineral content writes most of these; a full internal rebuild restores the toilet to boring reliability.
Shower temperature swings
A failing pressure-balance cartridge or scaled valve lets a toilet flush elsewhere in the house steal the shower's cold or hot supply. Cartridge work in the wall solves what turning the handle never will.
Slow tub or shower drain
Hair and soap ropes in the branch, often worsened by a tired drain assembly. Bathroom drains are cleaning territory until the pattern suggests the line itself — we test rather than assume.
Dripping tub faucet or shower head
Worn cartridges and seats let water past closed valves — into the drain all night, or down the wall if the leak is behind the trim. Volume makes small drips expensive here.
Vanity supply and trap leaks
Angle stops, supply lines, and slip-joint traps age inside a cabinet nobody inspects. The warped cabinet floor is usually the first report; the connections above it are the cause.
Remodel rough-in and fixture moves
Moving a toilet six inches is a drain, vent, and flange project; adding a shower where a tub stood is a valve and drain project. Rough-in done to survey, tested before tile, is what makes remodel bathrooms uneventful.
Guest bath that sat unused
Unused bathrooms fail politely: traps dry out and admit sewer odor, supply valves seize, toilet seals perish. A recommissioning visit — valves exercised, traps filled, seals checked — readies the room for guests.